Oil Discharge Monitoring Equipment ( O.D.M.E )

 

Oil Discharge Monitoring Equipment ( ODME ) is and environment protection system to meet MEPC MARPOL’s  requirements.

SYSTEM CONTAINS ;
 

Computer Unit
Oil Content Meter ( Analyser )
Flow Meter
GPS Signal ( From Bridge )
Speed Signal ( From Bridge ) 
Sample Pump
Overboard and Slop Tank Valves

ODME Is used to limit any oily water into sea according regulations.To do that , computer unit collects all data from mentioned components.

THE MAIN ODME REGULATIONS
 

ODME obligatory installation  - ARPOL 73/78 Annex I, regulation 15
Ships real time position inclusion mandatory for ODME installed after 2005 - Resolution MEPC.108(49)
Manufacturer recommended spares should be carried to ensure operation - Resolution MEPC.240(65)
By January 1st 2016, Oil Discharge Monitoring Equipment must be certified for Bio fuels in order for vessel to carry them - Resolution MEPC.240(65)

Regulation 34 - Control of discharge of oil
A Discharges outside special areas
 

1 Subject to the provisions of regulation 4 of this Annex and paragraph 2 of this regulation, any discharge into the sea of oil or oily mixtures from the cargo area of an oil tanker shall be prohibited except when all the following conditions are satisfied:

     .1    the tanker is not within a special area;
     .2    the tanker is more than 50 nautical miles from the nearest land;
     .3    the tanker is proceeding en route;
     .4    the instantaneous rate of discharge of oil content does not exceed 30 litres per nautical mile;
     .5    the total quantity of oil discharged into the sea does not exceed for tankers delivered on or before 31 December 1979, as defined in regulation 1.28.1, 1/15,000 of the total quantity of the particular cargo of which the residue formed a part, and for tankers delivered after 31 December 1979, as defined in regulation 1.28.2, 1/30,000 of the total quantity of the particular cargo of which the residue formed a part; and
.6    the tanker has in operation an oil discharge monitoring and control system and a slop tank arrangement as required by regulations 29 and 31 of this Annex.

WHAT WE DO

Control Technic is providing repair and  calibration service for all brands and models of oil discharge monitoring equipments.
To continue this , having all necessary calibration kits , sample waters and procedures are the requirements.
We advice onboard calibration instead of laboratory. This will keep safe oil content meter and save it from wrong re-installation after calibration.

We offer for ODME

* Calibration
* Repair
* Maintenance
* Retrofit
* New installation
* Comissioning
* Remote support
* Training for crew
* Spare parst supply